Relay Module Code/Headlight Control by Push Button

This module is an electronic relay to switch between low beam and high beam using a push button. Pressing the push button will change from low beam to high beam and vice versa. The module is designed to handle up to 60W (H4) continuous. 55W / 60W 2 wire bulbs can be used too. The control wires of the switch module can have very small diameters because the load on the control wires is very low. Typical application: Replacement of the rocker switch for OEM low beam and high beam. Replacement of the electro-mechanical light relay. Specifications: Size: 28 mm Cylinder Æ x 15 mm (waterproof sealed) Voltage range: 6 - 14 V Output current: max. 50 / 60 W (1 x 5.2 A @ 13.8 V) continuous Input: Non-latching switches need a ground connection. Attention: The relay can be installed in vehicles with on-board diagnostic system (BCM, CAN-bus). In this case, the production of DTC (diagnostic trouble code) or other indication of male function may occur. After installation check the correct operation of ABS / CAN-bus if installed! Only connect to 12 V DC.